monitor mode capturing wifi

I have a network, which has 2 nodes (a phone, a MacBook) both are connected to same wireless network, I know the SSID and password for the wireless network

password: mypassword
ssid: myssid
security: WPA2 Personal

I am currently running Wireshark on MacBook with following settings:

Edit > Preference > Capture > Interfaces > Edit

default buffer size `2048MiB`
default link layer header type: 802.11
monitor mode: checked

and to decrypt traffic under

Edit > Preference > Protocols > IEEE 802.11

Reassemble fragmented 802.11 datagram packets: checked
ignore vendor specific HT elements: unchecked
call subredisetor for retransmitted 802.11 frames: checked
assume packets have FCS: unchecked
Ignore the protection bit: Yes with IV
Enable decryption: checked
decryption keys: 
     key type: wpa-pwd
     key: mypassword:myssid

I start it in capture mode: I make a http call to foobar.com from my phone, and I expected wireshark to pick it up and display in sniffed data, I don't see it there.

However, if I make same HTTP call to foobar.com from my mac, I can see it being listed.

Edit:

I had to put my mac in wireless monitor mode, wireshark's monitor mode wasn't enough alone,

After that I see EAPOL handshake captured

but still it is not able to decrypt packets captured for that source (Lg_Electr_41), also attached protocol preference